Fitted to Your Spin, Not the Average Golfer's
TrueSpin Golf runs every session through a Doppler-radar launch monitor and a decade of in-house build experience. Driver, iron, wedge, or putter — the spec gets built around what your swing actually does, not a generic recommendation sheet.
One Club or the Whole Bag — Your Call
Every session opens with what's currently in your bag, a look at your swing data, and a straight conversation about what you're actually trying to fix.
Driver Fitting
Dial in launch angle, spin, and shaft profile to unlock distance and start-line consistency off the tee.
Learn more →Iron Fitting
Match lie, loft, length, and shaft flex across the set for tighter dispersion and better gapping.
Learn more →Wedge Fitting
Bounce, grind, and loft gapping tuned to your turf conditions and the shots you actually hit.
Learn more →Fairway Wood Fitting
Confidence off the deck and from the tee with heads and shafts built for your attack angle.
Learn more →Hybrid Fitting
Fill the long-iron gap with a hybrid that launches high and lands soft, matched to your set makeup.
Learn more →Putter Fitting
Length, lie, loft, and face balance measured against your stroke path and setup, not a chart.
Learn more →The "Average Golfer" Doesn't Exist
Off-the-rack clubs are engineered for a golfer with average height, average swing speed, and average tempo — a golfer who doesn't actually exist. A few degrees of lie angle or the wrong shaft flex quietly costs you accuracy and distance every round.
We run every session on a Doppler-radar launch monitor, test against a full demo fleet from major manufacturers, and build in-house — so new clubs are cut, built, and ready to play, usually within a week.
- Independent fitters — we're not tied to a single brand's quota
- Data from every swing, not just your best three
- In-house build shop for same-week turnaround
- Fitting fee credited toward any club purchase
| Club | Carry | Gap |
|---|---|---|
| 7-Iron | 158 yds | — |
| 8-Iron | 147 yds | 11 yds |
| 9-Iron | 135 yds | 12 yds |
| PW | 121 yds | 14 yds |
| GW (50°) | 106 yds | 15 yds |
From Interview to Finished Build in Four Steps
Interview & Goals
We start with your bag, your misses, and what you want the new clubs to fix.
Launch Monitor Session
Hit real shots with your current clubs and demo heads while we capture every data point.
Spec Recommendation
We walk through head, shaft, length, and lie/loft options backed by your own numbers.
Build & Verify
Clubs are built in-house and checked on our frequency machine before pickup.
What Changes After a TrueSpin Golf Session
My driver fitting added 11 yards of carry and cut my miss in half. The data made the shaft decision obvious — no upsell, just numbers.
I'd never been iron fit before. The lie angle on my old set was 3° flat and I didn't even know it. Ball flight is night and day now.
Full bag rebuild from a fitter who actually listened. Gapping is clean 1-through-wedge for the first time in my life.
Ready to Stop Guessing at Your Specs?
Sessions run 60–90 minutes and end with a full written report. Every fitting fee is credited toward any club build in our shop.